Now click on the next menu bar - Target Settings: Once you select a crossover type, minimize the Equalizer sub-window by clicking on its top bar again.
#Bryan adams heaven lyrics full#
The important settings here are "Full Range" if using you're equalizing a full range loudspeaker. REW can also help you with subwoofers and "bass limited", i.e., HT surround loudspeakers that are intended to cross above a certain subwoofer crossover frequency. LF slope indicates intended the slope of the roll-off of the low frequency end (12 or 24 dB/octave) corresponding to the crossover filter slope used between the loudspeaker and the subwoofer. If you look at the measurement plot that you are using to equalize, it will show you the lowest crossover frequency that you should use. For my Jubilees and K-402-MEH, that frequency is about 30 Hz. If you're using HT loudspeakers, it may be as high as 100 Hz. Set that LF roll off point to match your loudspeaker. The same settings are used for the high end.Īll of these settings are settable to new default values within the "Preferences" menu on the top bar of the REW main window. This is the place to put in your "house curve" if you choose to have non-flat loudspeaker response. You can boost or cut highs or lows using the above controls, and the resultant curve is visible, so you can see what your "goal curve" is.
I use flat response everywhere since I unmaster my recordings, but you may choose to use a "one size fits all" house curve to compensate for non-flat EQ used on your recordings. In the context of home theaters, that's what a "house curve" is doing. The last item on this menu is extremely important. It tells REW what SPL (loudness) to aim for overall when it optimizes the equalization PEQs. You want to get this right, or, not only does REW yell at you, it also will produce too many PEQs to try to flatten the response.
For the measurement above, 70 dB is the right answer. If you use a higher value, REW will try to boost all frequencies below your target level. If you use a setting that's too low, REW will attenuate everything to make that lower SPL. It's better to set this value 1 dB too low than 1 dB too high. It's better to attenuate using PEQs than to boost.
#Bryan adams heaven lyrics windows#
#Lyrics to heaven by bryan adams windows.
0 kommentar(er)
